/control/matScan/

Material scanner commands.

Sub-directories :

Commands :

scan

Start material scanning.
Scanning range should be defined with
/control/matScan/theta and /control/matSca/phi commands.

Available Geant4 state(s) : Idle

theta [nbin] [thetaMin] [thetaSpan] [unit]

Define theta range.
Usage : /control/matScan/theta [nbin] [thetaMin] [thetaSpan] [unit]
Notation of angles :
theta --- +Z axis : +90 deg. / X-Y plane : 0 deg. / -Z axis : -90 deg.

Available at all Geant4 states.

Parameters

nbin	type i		Parameter range : nbin>0
thetaMin	type d
thetaSpan	type d	Omittable : default value = 0	Parameter range : thetaSpan>=0.
unit	type c	Omittable : default value = deg	Parameter candidates : rad mrad sr deg radian milliradian steradian degree

phi [nbin] [phiMin] [phiSpan] [unit]

Define phi range.
Usage : /control/matScan/phi [nbin] [phiMin] [phiSpan] [unit]
Notation of angles :
phi --- +X axis : 0 deg. / +Y axis : 90 deg. / -X axis : 180 deg. / -Y axis : 270 deg.

Available at all Geant4 states.

Parameters

nbin	type i		Parameter range : nbin>0
phiMin	type d
phiSpan	type d	Omittable : default value = 0	Parameter range : phiSpan>=0.
unit	type c	Omittable : default value = deg	Parameter candidates : rad mrad sr deg radian milliradian steradian degree

singleMeasure [theta] [phi] [unit]

Measure thickness for one particular direction.
Notation of angles :
theta --- +Z axis : +90 deg. / X-Y plane : 0 deg. / -Z axis : -90 deg.
phi --- +X axis : 0 deg. / +Y axis : 90 deg. / -X axis : 180 deg. / -Y axis : 270 deg.

Available Geant4 state(s) : Idle

Parameters

theta	type d
phi	type d
unit	type c	Omittable : default value = deg	Parameter candidates : rad mrad sr deg radian milliradian steradian degree

singleTo [X] [Y] [Z]

Measure thicknesss for one direction defined by a unit vector.

Available at all Geant4 states.

Parameters

X	type d
Y	type d
Z	type d

eyePosition [X] [Y] [Z] [Unit]

Define the eye position.

Available at all Geant4 states.

Parameters

X	type d	Omittable : default value = 0
Y	type d	Omittable : default value = 0
Z	type d	Omittable : default value = 0
Unit	type s	Omittable : default value = m	Parameter candidates : pc km m cm mm um nm Ang fm parsec kilometer meter centimeter millimeter micrometer nanometer angstrom fermi

regionSensitive [senseFlag]

Set region sensitivity.
This command is automatically set to TRUE
if /control/matScan/region command is issued.

Available at all Geant4 states.

Parameters

senseFlag

type b

Omittable : default value = 0

region [region]

Define region name to be scanned.
/control/matScan/regionSensitive command is automatically
set to TRUE with this command.

Available at all Geant4 states.

Parameters

region

type s

Omittable : default value = DefaultRegionForTheWorld